Home Addition Cure Silicone Putty Condensation Cure

Elastosil M 4642 US                                                 

 

 

Elastosil M 4642 US A/B is an RTV-2 silicone rubber well suited to Mold Making applications.  It's a pourable, addition-curing, very high strength silicone that can be vulcanized at room temperature, or at elevated temperatures to increase the rate of cure.

Features

  •  cures to nominal 37 duro Shore A hardness
  •  very good flow
  •  non-shrink cure at room temperature
  •  cure can be accelerated by the application of heat
  •  excellent long-term stability of cured product's mechanical properties
  •  suitable for reproducing models with undercuts that will be reproduced in casting resin

Basic Typical Physical Properties

RubberWorks RTV Data Sheet

Elastosil M 4642 US A/B

Property Test Procedure Component A   Component B
Appearance   White   Brownish Red
Density, 23 C, g/cm3 DIN 52 479 A 1.15   1.00
Viscosity, 23 C, cPs Brookfield 25,000   700
      Mixed 10:1 Ratio  
Hardness, Shore A DIN 53 505   37  
Tensile Strength, psi DIN 53 504 S3   940  
Elongation at Break, % DIN 53 504 S3   500  
Tear Resistance, ppi ASTM D624, B   170  
Linear Shrinkage, %     < 0.1  
Viscosity, 23 C, cPs Brookfield   20,000  
Appearance     Brownish Red  
Typical Values Shown are not intended for use in the preparation of specifications

Contact RubberWorks for a complete Wacker Data Sheet describing this Elastosil product

M 4642 US is supplied in kits consisting of A and B Components

            Call RubberWorks for the detailed Wacker Elastosil Data Sheet

 

Home ] Up ]

Send mail to Info@RubberWorksInc.com with questions or comments.  RubberWorks Inc is your Canadian source!
Last modified: December 28, 2010

Elastosil, Semicosil, and Powersil are registered trademarks of Wacker Chemical.